/* Pro Micro Test Code

Code von https://codebender.cc/sketch:77845#Pro%20Micro%20Blink.ino
Zuerst musste unter Ubuntu der Modem Manager entfernt werden mit, s. https://community.arduboy.com/t/resolved-issues-uploading-with-ubuntu-18-10-and-arduino-1-8-9/7447/4
  sudo systemctl disable ModemManager.service

In den Preferences die zusätzliche Quell-URL eintragen, s. https://learn.sparkfun.com/tutorials/pro-micro--fio-v3-hookup-guide/all#installing-mac--linux
  https://raw.githubusercontent.com/sparkfun/Arduino_Boards/master/IDE_Board_Manager/package_sparkfun_index.json
Danach über den Board Manager die Sparkfun AVR installieren und als Board "Sparkfun Pro Micro" und Provil 5V 16MHz auswählen.

Upload über den neuen seriellen Port /dev/ACM3


Troubleshooting, wenn bricked:
- ModemManager abschalten
    sudo systemctl disable ModemManager.service
- Pro Micro mit USB-Port verbinden
- 2x schnell hintereinander RST mit GND verbinden, danach 8s Zeit für den Upload https://learn.sparkfun.com/tutorials/pro-micro--fio-v3-hookup-guide/troubleshooting-and-faq#ts-revive
- Upload mit
    sudo ./arduino --upload /root/Arduino/pro_micro/pro_micro.ino --port /dev/ttypACM3

Auch hilfreich:
  ls /dev/ttyA*
  lsusb

*/

#include "Keyboard.h"

const int RXLED = 17;  // The RX LED has a defined Arduino pin
const int buttonPin = 2;
int buttonState = 0;
int prevButtonState = HIGH;

void setup() {
  Serial.println("Hello Keyboard World");
  pinMode(RXLED, OUTPUT);  // Set RX LED as an output
  pinMode(buttonPin, INPUT_PULLUP);
  digitalWrite(buttonPin, HIGH);
  Serial.begin(9600); //This pipes to the serial monitor
  Keyboard.begin();
}

void loop() {
  buttonState = digitalRead(buttonPin);
  if ((buttonState != prevButtonState) && (buttonState == HIGH)) {
    Serial.println("Now pressing button");
    
    // Here starts the output action
    //Keyboard.press(KEY_LEFT_GUI); // Command key in Mac, use KEY_LEFT_CTRL for Pc
    Keyboard.press('v');
    delay(100);
    Keyboard.releaseAll(); // This is important after every Keyboard.press it will continue to be pressed

    digitalWrite(RXLED, LOW); // set the LED on
    delay(300);
    digitalWrite(RXLED, HIGH); // set the LED off
  }
  prevButtonState = buttonState;
}